308 AR10 lower receiver vise block - gunsmithing tool
- 8.00 Ounces
- Calculated at Checkout
I bought the block to work with a 5D technical 308 lower. The block would not fit in the clip area. There was a bow in the block so it was to wide to be used. I took a grinder to both sides and know it fits perfect.
This block was bulged in the middle and would not fin in my mag well. Machined about .050" off each side and it works fine.
If you have access to a Mill it can be fixed in about 60 seconds. Otherwise you would have to file it by hand which could be time consuming as it is made out of good hard fiber reinforced plastic.
Would be five stars if fit out of the box.